I’ve been teasing this project for a while now and decided it was time to release it. The keyboard itself is handwired just like all my other boards but this time it is split and uses VGA cables to connect the two halves. The switches are stock Outemu Blues and the board is powered off by an Arduino Pro Micro running QMK. The keycaps are DSA Astrolokeys from Drop. ~ Links ~ My Keyboards: Cases, Keyboards, and Keycaps: ~ Parts ~ - Arduino Pro Micro - - 1N4148 Diode - - 8mm M2 Spacer - - M2x6mm Screw - - Switches - - VGA Connectors: - VGA Cable: ~ Tools ~ TS100: 63/37 Solder: ~ Social ~ ~ Disclaimer ~ Some links may be affiliate links where I will make a small commission. Nothing in this video was sponsored by any outside party and I wasn't paid for the content in this video. #mechanicalkeyboard #3dprinting #electronics