Welcome to Part 2 of an eight part series discussing Access Control Lists on Cisco IOS Routers. In this video we will be picking apart the syntax to configure Numbered ACLs on Cisco Routers. I'll show you the command, and then we'll talk through each field. 0:00 - Start / Review of Part 1 0:42 - Two sets of Syntax (Named vs Numbered) 1:05 - Syntax for Numbered ACL (Standard and Extended) 1:26 - Command: access-list 1:37 - ID Number 3:28 - Action 4:42 - Protocol 5:37 - Source and/or Destination 5:57 - Specifying IP Address 6:39 - Specifying Ports 8:11 - Summary and Outro Part 1 - What are Access Lists? Part 2 - Numbered ACL Syntax Part 3 - Numbered ACL Configuration Demonstration Part 4 - Named ACL Syntax Part 5 - Named ACL Configuration Demonstration Part 6 - IPv6 ACLs - Syntax and Demonstration Part 7 - Applying ACLs to Interfaces Part 8 - Where should you apply ACLs (closer to source or destination?) Entire Series: