This shows one way to make a two-part "push mold" from silicone putty. Since each half cures in under 30 minutes, a mold can be made in around an hour. From this mold, copies can be made using Apoxie Sculpt, Sculpey, Play-Doh, 2-part Epoxy Putty, and more. Toys and figures playlist! : We couldn't do what we do without direct support, so if you would like to be a part of keeping us going, please consider supporting us directly through: Patreon, Paypal OR Ko-fi: (On Patreon, you'll also get access to the printable 3D scans of my original sculpted figures, MP3s, exclusive behind-the-scenes videos, shop discounts, and more.) My family and I are so grateful that I get to do this. STICKERS, PINS AND FIGURES WHEN AVAILABLE FULFILLED BY US: MUGS, SHIRTS AND MORE FULFILLED BY SPRING: AMAZON AFFILIATE STOREFRONT: FACEBOOK INSTAGRAM @steadycraftin GEAR I USE: CAMERAS: MICROPHONE: LIGHTS: TRIPODS: SUPPLIES USED: * Polly Plastics Mold Putty: Aves Fixit Sculpt Aves SafetySolv Clay Sculpting Tool Set Lumina Polymer Clay AFFILIATE LINK NOTICE “As an Amazon Associate I earn from qualifying purchases.”