Please Note: These parameters are set outside of the Wizard. Running the Wizard will reset them back to the defaults. Parameter 968 Value Frequency (Hz) 0 200000 1 1200000 2 600000 3 400000 4 300000 5 240000 6 200000 12 100000 30 40000 60 20000 100 12000 Parameter 39 - Feedrate Override Percentage Limit This parameter is used for limiting the upper end of the Feedrate Override Knob percentage to a value from 100% to 200%. This parameter can be used to restrict the Feedrate Override Knob effect on machines with maximum rates over 200 in/min. The Feedrate Override Knob percentage is normally allowed to go to 200%. However, on machines with high cutting speeds, if the knob is turned up to 200%, it creates overshoots on corners. If this parameter for example is set at 110, it will stop the Feedrate Override Knob from exceeding 110%, and thus cause the overshoots to disappear. Parameter 146 – Feed Hold Threshold for Feed Rate Override This parameter sets the lowest value permitted as the feed rate override percentage before feed hold is engaged. Feed hold will be released when the override percentage is greater than this value.