I built a custom water-cooled heatblock for the Raspberry Pi 5 using the new Carvera Air desktop CNC! This one-of-a-kind block features a milled aluminium cold plate, a clear acrylic distribution plate, and a built-in pump, all connected with hardline tubing to an 80mm radiator. It’s total overkill, but the thermal test results are impressive! #RaspberryPi5 #CNC #CarveraAir ADDITIONAL INFORMATION --------------------------------------------------- Check out the Carvera Air by Makera - Use my coupon code below to get $100 off the Carvera or Carvera Air MichaelK100off Once per order, one use per customer Visit my blog for the project write-up - PURCHASE LINKS --------------------------------------------------- Raspberry Pi 5 - Low Profile Pump - 80mm Radiator - 80mm Slim Cooling Fan - 12mm Hardline Tubing - 12mm Compression Fittings - Adjustable Power Supply - Tools & Equipment Used: Makera Cavera Air - Carvera Air Bits - Bambulab P1S Combo - Pipe Bending Kit - 8mm Silicon Bending Insert - Milwaukee M18 Heat Gun - Some of the above parts are affiliate links. By purchasing products through the above links, you’ll be supporting this channel, at no additional cost to you. CHAPTERS --------------------------------------------------- 0:00 Intro 0:54 Designing The Components 2:38 Making The Components 6:08 Assembling The Block 8:58 Block Complete! 10:21 Thermal Tests 11:40 Final Thoughts If you've got any ideas for Raspberry Pi, Arduino, or other Electronics projects or tutorials you'd like to see, let me know in the comments section.